Installation
RELEASING OF THE TRANSPORT SAFETY PINS DURING AND AFTER THE INSTALLATION
All rescue parachute ballistic systems GRS are secured ,from 2002 on, by the transport needle designated as the safety A which goes through the activation launching peg and by the safety designated as B, which is the bolt M5 that secures the rocket engine position in the rocket tube during transport.
These two transport safeties are firmly connected between themselves by the little red flag and must be step by step taken out!
After unpacking you first unscrew the safety B in the rocket tube rear part but leave the red little flag attached until the system is installedand (in case of modification Soft, it is necessary to lift off the upper fabric cover of the rocket tube on velcro zips and take out the bolt M5).
After the system installation you snip the wire safety A , take it out and remove the flag and the system is now secured only by the operational pin with the flag on the handle.It is released by pilot shortly before flight and after the flight applied again so that the handle is secured against possible activation
WARNING: If the cockpit cannot be locked then the handle must be locked.
Packing of product
- Transport saf1. Safety A- of steel wire diameter 2 mm, B M5 bolt.
- Transport steel basket.
- Operational safety pin with little flag.
- Transport screws 2 x M5.
PŘED EXPEDICÍ NÁS PROSÍM KONTAKTUJTE !
Avant l´achat merci de nous contacter!
SZÁLLÍTÁS ELŐTT ÉRTESÍTSE A GYÁRTÓT!
PRIMA DELLA SPEDIZIONE CONTATTATECI!
Przed wysłaniem systemu skontaktuj się z producentem aby uzyskać najnowsze informacje.
Before installation the user must read and understand this manual. Failure to do this or overlooking important information while installing or maintaining the system in accordance with the instructions and advice in this manual could result in personal injury or death to you or your passangers and damage to your aircraft. If you have any questions or are unsure of any part of this manual, get advice from an agent or the factory before proceeding.
Galaxy wishes you to fully understand the proper use of the GRS for your safety and that of your passengers. Do not replace any part with a similar part you may have obtained elsewhere. The manual is explicit in the proper mounting procedures required for safe installation and in the proper use of the system. Do not under any circumstances vary from the described methods or components supplied without first getting approval from Galaxy.
